If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yes, no problem whatsoever. Start off putting 50ml of the concentrated TFR into the bottle then add 950ml of warm water, 1:19 dilution ratio. Quick shake and away you go. Apply to bodywork, wheels, arches etc, leave to work for about 5 minutes then pressure rinse off.
Remember though, it may not be a 100% effective dirt remover on your car as it is on mine as mine is very well protected. It is after all just one step within the wash process to ensure a much safer wash. You will probably still have to clean it with a mitt and shampoo BUT you will have a much cleaner car to start with and won't be moving as much dirt around with your mitt. Hope this helps?
Andy
Andy DS3 Club's Resident OCD Detailer!
Take a pride in your ride
@cleanyourride_uk
Always best to apply foam/TFR/pre-wash to a dry car as it grabs the dirt better. Product slides off easier and is therefore less effective on a wet car DT[emoji106]
Andy DS3 Club's Resident OCD Detailer!
Take a pride in your ride
@cleanyourride_uk
Always best to apply foam/TFR/pre-wash to a dry car as it grabs the dirt better. Product slides off easier and is therefore less effective on a wet car DT[emoji106]
Comment