Holder for loose change

[Mr.C]

Does anybody have/know of a good holder for loose change which fits in one of the cubby holes in a DS3?

My C8, which had loads of cubby holes, had a built in holder with about 10 slots which held coins, which was very handy for car park meters etc.

Anybody who suggests a coin purse will be tracked down, and in the words of Jeremy Clarkson, "shot"

[mix]

All my loose change goes in the arm rest along side the load of other rubbish I have in there.

[Bigfeet]

This perhaps?



or this?



Part numbers 9425 E4 and 9425 C9

[Mr.C]

Well done Biggie. Thanks for that.

I quite like the look of the bottom one 9425 C9. However, can't quite tell from the picture but do you know if that is a lid that closes which has been raised for the picture?

Presumably, they are standard size and fit all DS3's.

[Bigfeet]

It would have a lid in my opinion.

[cyclone]

Yes lid. don't have one but have seen one.

[ZACK]

Deffo Has A Lid,

My Mate Has One In His C2 Code

[billy smith]

all my loose change ends up in the mrs's purse so no need for 1 ere lol

[Woolsy]

i suggest you invest in one of these

[Petewete]

you could give it to this poor bastard.....

[Mr.C]

Can't be that hard up.

Can still afford fags!

[Petewete]

lol, but not shoes!

[Skittso11]

My own cupholder.

Hi Guys, decided that I was sick and tired of hanging onto my Latte from Maccas every time I bought one whilst going for a drive. I have attached a couple of photos. I made it out of 80mm plastic water pipe,3mm flat plastic sheet, 406 locktite superglue, piece of aluminium 25mm flat bar 3mm thick and a leather welding glove. It fits onto the side of the consol and into the lower vent. Worked brilliantly on the weekend. I glued a piece of flat plastic to the bottom of the pipe. Bent up the aluminium flat bar to the best shape fitted the consol and into the vent. Glued and rivited the aluminium to the side of the pipe and then covered in the leather of the welding glove ( by the way the glove was brand new and not been used) . Turned out great and if you have a passanger you can remove it, as it will be in there way. You can how ever still slide the seat forward and it doesn't get in the way. hope this helps someone.

[billy smith]

skitts get a patent on it and churn a few out on ebay im sure there will be loads buy them lol nice work :cool:

[pat40]

I would definitely buy one!