Tweet
Indicating DRL / LEDs
Wanted to share what ive been upto the past few months,
I bought a pack of 20 12v ambient LEDS lights from ebay, and a pack of 5 mini realys from banggoods
and decided to make my DRL flash(indicate), like most new cars today.
I followed http://www.ds3club.co.uk/showthread....fender+removed (Thanks to Eiken)
and removed the DRLS, cleaned them up then tried rippng them apart which was the longest part of this project! in the end i ended up putting it in the over
praising it open and kept repeating this until it finally come apart, took about a day too open both DRLs after that i cleaned out most of the old glue as i could
then used a screw driver to make the holes, after my 5mm LEDs fitted nicely i glued them in, then started on the wiring,
Before i put in the relay/diode/capacitor, i tested everything on a bread board,
After a bit i just cracked on and just done it, here's the end results.
https://youtu.be/w_kqdVyHFgQ
Components used..
2x 1000uf 16v capacitor out of an old motherboard
12x12v ambiant 5mm LEDs DC Bulbs Light MA438 H5 from ebay
2x SONGLE Mini 12V DC Power Relay SRD-12VDC-SL-C PCB Type from banggoods
2x 1N4004 diode(i think) from an old motherboard
if i could go back and change something it would be the LEDS, you cannot see them in the daylight it just looks like an broken DRL lolz
anyways i will sort that out sometime in the future. thanks
I bought a pack of 20 12v ambient LEDS lights from ebay, and a pack of 5 mini realys from banggoods
and decided to make my DRL flash(indicate), like most new cars today.
I followed http://www.ds3club.co.uk/showthread....fender+removed (Thanks to Eiken)
and removed the DRLS, cleaned them up then tried rippng them apart which was the longest part of this project! in the end i ended up putting it in the over
praising it open and kept repeating this until it finally come apart, took about a day too open both DRLs after that i cleaned out most of the old glue as i could
then used a screw driver to make the holes, after my 5mm LEDs fitted nicely i glued them in, then started on the wiring,
Before i put in the relay/diode/capacitor, i tested everything on a bread board,
After a bit i just cracked on and just done it, here's the end results.
https://youtu.be/w_kqdVyHFgQ
Components used..
2x 1000uf 16v capacitor out of an old motherboard
12x12v ambiant 5mm LEDs DC Bulbs Light MA438 H5 from ebay
2x SONGLE Mini 12V DC Power Relay SRD-12VDC-SL-C PCB Type from banggoods
2x 1N4004 diode(i think) from an old motherboard
if i could go back and change something it would be the LEDS, you cannot see them in the daylight it just looks like an broken DRL lolz
anyways i will sort that out sometime in the future. thanks
Comment