Signal/Remote wire for sub and amp install !?

[HANENG18]

Hi all,
I am in the middle of installing a custom slot ported sub box into the spare wheel well. I have got the power cable routed to the rear, but now I am stuck at the signal/remote wire. I am following this guide - http://www.ds3club.co.uk/showthread....hout-Connects2


But the thick blue wire is constant 12v. So if I use this, it means my amp will be constantly turned on! Also the same blue wire at the the back of the head unit is a constant 0v with ignition on and off! I have belled out the wire blue wire front to back of the car to make sure I am looking at the same wire and it IS the same! I have tried every other wire in the plug for the factory sub, but no luck! Any ideas of what I can use to for the remote wire then? I have a DSport 2011 hdi if that helps.

Thanks

-Harry

[katoon]

Did you ever get this fixed as i have the same problem

[MARK.A]

The blue wire is only constant live for around 10 mins after the car shuts down the relays

[Mezzy78]

Did you ever get this fixed as i have the same problem

Hi guys, I'm just about to install my system and have looked into this issue. I have found that if you go into the fuse box in the glove box and locate fuse F11 this is a 12v ignition fuse and as such should provide the remote live needed. Like I say I have not installed mine as yet so I can not confirm this, but it does seem to be the case.

All I need to do now is figure out the speaker wires so I can install my high to low converter

[MARK.A]

Or you can just tap off the all blue wire in the radio multi plug that's where I did mine