If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
3 mount clips and an alignment/holder piece center bottom and another clip piece that fits into that triangle shaped hole.
Pop the clips out and slide the trim a wee bit forwards as your pulling it off to disengage that little sideways U piece on bottom of trim.
As long as the 3 clips are OK it will go back on and hold just fine. Would have done pics yesterday for you but was getting ready to leave.
Originally posted by cyclone
It is in the handbook. Satisfied.
Originally posted by Broda
I would rather teabag a bear trap
Comment