Tweet
I tried removing it but there is a part that just wont budge,
Red bit in the photo
http://i.gyazo.com/cf47f2e113b40a13d93e8b239d2dd9ad.png
Red bit in the photo
http://i.gyazo.com/cf47f2e113b40a13d93e8b239d2dd9ad.png
-
-
Have took my door card off before, I'm sure that trim just clips in, ease it out from the inner edge as that's where it clips in.White on red THP
Miltek exhaust with HKS highflow cat, Forge intercooler, hard pipe kit, induction kit, oil catch tank, , VAG BOV, Stage 3 SPT remap 217 BHP -
Yet again it might have come off with the door card....
:-/White on red THP
Miltek exhaust with HKS highflow cat, Forge intercooler, hard pipe kit, induction kit, oil catch tank, , VAG BOV, Stage 3 SPT remap 217 BHPComment
-
No you are right it just clips in. Have had mine offOriginally posted by cyclone
It is in the handbook. Satisfied.
Originally posted by Broda
I would rather teabag a bear trapComment
-
Thanks cyc
White on red THP
Miltek exhaust with HKS highflow cat, Forge intercooler, hard pipe kit, induction kit, oil catch tank, , VAG BOV, Stage 3 SPT remap 217 BHPComment
-
Got round the edge bits but there is a bit just next to the door handle that is different from the rest of the clips.Comment
-
-
Done snappedComment
-
-
Will it fit back in secure?Comment
-
-
Not sure where you could have gone wrong.
3 mount clips and an alignment/holder piece center bottom and another clip piece that fits into that triangle shaped hole.
Pop the clips out and slide the trim a wee bit forwards as your pulling it off to disengage that little sideways U piece on bottom of trim.
As long as the 3 clips are OK it will go back on and hold just fine. Would have done pics yesterday for you but was getting ready to leave.Originally posted by cyclone
It is in the handbook. Satisfied.
Originally posted by Broda
I would rather teabag a bear trapComment
Comment