Does anybody want to advise me how to fit a zunsport girlle? I've bought one and the instructions aren't very useful to me lol
Announcement
Collapse
No announcement yet.
Zunsport Grille
Collapse
X
-
Fitting:- Take bumper off, guide here EDIT: don't do that
- Put new grille in place, see below
- Fasten with screws, see below
Without chrome:
Might be a different size to fill the gaps where the chrome isn't, I'd contact them to make sure.
Comment
-
Originally posted by lfcrule1972Hey Ben - have Zunsport changed their grilles ? I didn't have to remove my bumper when I fitted mine to my DS3.
I held it up to the bumper and pushed it until the clips engaged and then carefully drilled holes for the four screws in the plastic trim.
That was all I needed to do....
Comment
-
Ahh I thought I remembered seeing someone removing the bumper. Think I'm getting confused with Berch and Funky and their grey DS3s - one with a Zunsport, one with a facelifted bumper.
Comment
-
No worries, I thought they might've been changed.
In which case, the steps (from memory) are:
1. Offer the Zunsport Grille (ZG) up to the lower part of the bumper and gently push it in until the clips engage
2. Stand back and check that the ZG is aligned centrally
3. Gently push the edges in towards the lower bumper - the screw holes on the ZG should align with the solid plastic part of the lower bumper trim.
4. Either mark the four holes for drilling or drill them whilst holding the ZG in place (small drill check size against screws supplied with the ZG)
5. Once all four are drilled, screw the ZG into the lower bumper trim
6. Check alignment before fully tightening, there shouldn't be any issues though
7. Stand back and enjoy this fine modsigpic
- 1 like
Comment
-
Originally posted by BenS View PostAhh I thought I remembered seeing someone removing the bumper. Think I'm getting confused with Berch and Funky and their grey DS3s - one with a Zunsport, one with a facelifted bumper.DS3 DSport eHDi 145 - Stage 1 with K&N - Shark Grey & Infinite Blue
Comment
-
Originally posted by lfcrule1972 View PostNo worries, I thought they might've been changed.
In which case, the steps (from memory) are:
1. Offer the Zunsport Grille (ZG) up to the lower part of the bumper and gently push it in until the clips engage
2. Stand back and check that the ZG is aligned centrally
3. Gently push the edges in towards the lower bumper - the screw holes on the ZG should align with the solid plastic part of the lower bumper trim.
4. Either mark the four holes for drilling or drill them whilst holding the ZG in place (small drill check size against screws supplied with the ZG)
5. Once all four are drilled, screw the ZG into the lower bumper trim
6. Check alignment before fully tightening, there shouldn't be any issues though
7. Stand back and enjoy this fine modDS3 DSport eHDi 145 - Stage 1 with K&N - Shark Grey & Infinite Blue
Comment
-
All I can think of, is that you bought the lower grille for the earlier models, that fits on the DS3's without the chrome surround.
Check here and you will see the difference:
Citroen Grilles from Zunsport. Providing a wide range of Citroen Car Grilles for a large range of models.DS3 DSport eHDi 145 - Stage 1 with K&N - Shark Grey & Infinite Blue
Comment
-
Originally posted by Funky View PostAll I can think of, is that you bought the lower grille for the earlier models, that fits on the DS3's without the chrome surround.
Comment
Comment