If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi, i have a non functioning reverse light. Checked the bulb, wiring, switch and all fuses, still nothing.
Could this be a BSI issue? Anyone any ideas?! Thanks
I suspect you have a fine covering of powder on the pins of the gearbox switch/connector.
I had this on my 206 GTi180 once. I bridged a wire across the connector and the reverse lights came on when the ignition was on, so I assumed it was a dodgy switch on the gearbox.
After cleaning the connector and switch pins with electrical cleaner then spraying it with Maxsolve 200 spray it worked again and never had a problem afterwards.
I'll mention that Maxsolve 200 is not WD40
Regards,
Simon
2011 DS3 DSport (Sport Red with Onyx Black Roof).
2014 208 GTi (Calado Blue).
I suspect you have a fine covering of powder on the pins of the gearbox switch/connector.
I had this on my 206 GTi180 once. I bridged a wire across the connector and the reverse lights came on when the ignition was on, so I assumed it was a dodgy switch on the gearbox.
After cleaning the connector and switch pins with electrical cleaner then spraying it with Maxsolve 200 spray it worked again and never had a problem afterwards.
I'll mention that Maxsolve 200 is not WD40
Thanks for the idea but already bypassed the reverse switch and still no light.
I am pretty much down to the BSI but not actually confirmed this yet. Was hoping to find a pin out for the BSI but had no luck.
Comment