If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
These -25mm springs are also TÜV approved, but the -35mm springs from H&R are not approved.
This must be for the same reason
Check the German web site again, the 30-35mm do have a teilegutachten same as the 20-25mm springs. Either set would be have no problem getting thru TUV.
So go low
Originally posted by cyclone
It is in the handbook. Satisfied.
Originally posted by Broda
I would rather teabag a bear trap
Yes correct, my bad.
What I ment to say was that these springs also are ABE approved.
I'm told that this means that this part also won't harm the vehicle.
That's fine, just so you know here in Germany an ABE is a Allgemeine Betriebserlaubnis that means is that the part (modification to the auto) does not have to be entered in the car's papers. Any aftermarket springs, including the 20-25mm H&R's, as a major modification to the car would have to be looked at by big brother "TUV" and entered in the car"s papers.
Originally posted by cyclone
It is in the handbook. Satisfied.
Originally posted by Broda
I would rather teabag a bear trap
So, dropped the car this afternoon. Can pick it up by tomorrow afternoon.
Now driving an DS4 THP200, what a great car. Interior is much better then the DS3, and the enginesound is totally different. :cool:
Comment